1. The bottom diameter and bottom flange size of the solar Street Lamp pole should meet the design requirements. If there are special requirements, the manufacturer shall provide detailed drawings of the corresponding products for Party A and design considerations. The Solar Street Light steel material must meet the standards.
2. The inside and outside of the solar Street Lamp Post should be treated by hot dip galvanized inner and outer surface anti-corrosion and other processes. Yangzhou Sino-US New Energy Lighting recommends that the galvanized layer should not be too thick, without color difference or roughness on the surface. The above anti-corrosion treatment process should meet the corresponding national standards. During the construction process, anti-corrosion test reports and quality inspection reports on the light poles should be provided.
3. The surface of the solar street lamp pole needs to be color sprayed, and the color should meet the requirements of the owner. Spray paint should use high-grade paint.
4. The pole of solar street lamp shall be calculated according to the wind speed force specified in the national standard, and the force requirements. During the construction process, material descriptions and stress calculations related to the light poles should be provided. It is recommended that for light poles welded with steel rings, the contractor should clean the welded joints before welding and make a bevel according to the regulations.
5. The hand hole door of the ordinary street lamp pole of solar street lamp , the design of the hand hole door should be beautiful and elegant. The door is plasma cut. The appliance door should be integrated with the rod body, and the structural strength should be good. With reasonable operation space, there are electrical installation accessories in the door. The gap between the door and the rod should not exceed one millimeter, with good waterproof performance. There is a special fastening system with good anti-theft performance. The electrical door should have high interchangeability.
6. The installation of solar Street Light Poles shall comply with the relevant regulations in the relevant national installation regulations and safety regulations. Before the installation of the Light Pole, the appropriate lifting equipment should be selected according to the height, weight, and site conditions of the light pole. The location of the lifting point and the method of displacement and correction should be reported to the supervision engineer for approval. Check and calibrate to ensure the lamp pole is in the correct position and the shaft is vertical.
7. When the solar street lamp is connected by bolts, the screw should be perpendicular to the penetration surface, there should be no gap between the screw head plane and the component, and there should be no more than 2 washers at each end . After the bolt is screwed, the length of the exposed nut is not less than two Pitch.
8. After the installation and correction of the solar street lamp pole, the contractor shall immediately carry out backfill tamping. The backfill tamping shall comply with the relevant regulations.
9. The installation of solar street lamp power discharge pipes shall comply with the drawings and relevant specifications.
10. Verticality inspection of solar street lamps: After the pole is upright, use the theodolite to check the verticality between the pole and the horizontal.
11. The overall appearance of the solar street lamp pole: the shape and size meet the requirements, the overall appearance is elegant, the surface of the pole body is smooth and consistent, and the color is uniform.
Yangzhou solar street lamp manufacturers mainly produce and sell: solar street lamp series, Led Street Lamp series, high pole lamp series, Chinese lamp series, courtyard lamp series, lawn lamp series, various other special street lamp series, undertake road lighting projects,
